Extron Electronics VTG 400D_400 DVI User Guide - Manual (Page 49)

3-13 VTG 400D/400 DVI • Serial Communication
7. When the installation is complete, close the Software products screen. You
can now start the Windows-based control program.
Downloading the VTG 400 software from the Web
The VTG 400 Windows-based control program is also available on the Extron
Web site at www.extron.com. From this site, you can also download updates to
the VTG 400 software as they become available.
To access the software on the Web,
1. Open the Extron Web page, and select the Download tab.
2. On the Download Center screen, click the
Control Software
button (shown at right). A Control
Software screen is displayed, containing a list of control
software products.
3. In one of the linked alphabets displayed across the top and bottom of the
screen, click V.
4. On the “V” software products page, scroll to locate the VTG 400/400D, and
click the Download link at the far right.
5. On the next screen, fill in the required information.
6. Click the Download VTG400SW1xn.exe button.
7. On the File Download - Security Warning window that appears, click Run
to begin downloading the installer file.
If you want to save the installation file (VTG400SW1xn.exe) to your
computer hard drive to run later, click Save. On the Save As window that
opens, save the setup file to the desired location. When you are ready to
install the software, double-click on the VTG400SW1xn.exe icon, and
follow the instructions.
8. On the second security prompt window that opens, click Run again to start
the installation process.
9. Follow the instructions on the InstallShield Wizard screens to complete the
software program installation. By default the installation creates a folder
called “VTG400” in the following location on the computer:
c:\Program Files\Extron\VTG400
If there is no Extron folder in your program Files folder, the installation
program creates it.