Extron Electronics VTG 400D_400 DVI User Guide - Manual (Page 27)

2-17 VTG 400D/400 DVI • Installation and Operation
• 5 minutes
• 10 minutes
• 15 minutes
• 30 minutes
• Never time out (default — screensaver is not activated)
The following LCD display message is updated approximately every 38 seconds
starting with the timeout interval selected.
Time-out in:
00:18 minutes
After the timeout interval has has elapsed, the following LCD message is
displayed.
SCREEN SAVER
ACTIVE
The timeout timer is reset whenever any VTG button is pressed.
Screensaver Mode
The screensaver mode can be set to a blank (black) screen or the mode can be set
to cycle through all valid test patterns in 4-second intervals for the video type.
• Blank (default)
• Cycle
In blank screen mode, the sync remains active even while the video is muted.
Refer to the Test Pattern Chart in
appendix A for the table of available test
patterns and their features.
Advanced Setup submenu (2 of 4)
The VTG’s LCD display features an adjustable contrast setting and a backlight.
LCD Display Contrast
• 000 through 063, select a setting while observing the LCD
LCD Backlight
The LCD backlight on the VTG can be set to remain on or to automatically turn
off after 10 seconds of inactivity.
• Always On
• Auto (default)
Advanced Setup submenu (3 of 4)
The VTG’s LCD displays the internal board temperature of the VTG in degrees
Celsius and degrees Fahrenheit.
The native rate for a DVI device connected to the VTG 400 DVI is displayed on
the LCD. This information is detected from the EDID generated by the attached
DVI device.