Extron Electronics PIP 444 User Guide - Manual (Page 45)

4-9 PIP 422 and PIP 444 Picture-in-Picture Processors • Remote Control
Command/response table for special function SIS commands
The syntax for setting a special function is
Xn
*
X?
# where
Xn
is the value or variable
(such as 1 in the first example below),
X?
is the function number (such as “Set text
location” in the first example below), and # is the execute command. To view a
function’s setting, use
X?
# where
X?
is the function number.Command/response
table for special function SIS commands
Command ASCII Command Response Additional description
(host to PIP) (PIP to host)
Text location
Set text location X22 *1# Tlc X22 Set window text position to X22 .
View text location 1# X22 Show text position.
Text style
Set text style X23 *2# Txs X23 Set window text style to X23 .
View text style 2# X23 Show text style.
Background color
Set background color X24 *3# Bkg X24 Set background color to X24 .
Example: 2*3# Bkg2 Set background color to cyan.
View background color 3# X24 Show background color.
Border color
Set border color X25 *4# Bdr X25 Set border color to X25 .
Example: 3*4# Bdr3 Set border color to green.
View border color 4# X25 Show border color.
Window insertion effect type
Set effect type X26 *5# Eff X26 Select insertion effect type.
Example: 2*5# Eff2 Set insertion effect type to wipe.
View effect type 5# X26 Show insertion effect type.
View window preset parameters
Initiate view mode X14 *6# Vpr X14 Enters preset view mode for
{view command} {command response} preset X14 ; the next view
command applies to the
parameters stored in that preset.
This mode will end after 5
seconds of inactivity or
immediately following the next
command. This mode only
applies to view commands; other
commands are unaffected.
Example: 2*6# Vpr2 View the window vertical sizing
1*2; 150 for input 2 stored in preset 2.