Extron Electronics PIP 444 User Guide - Manual (Page 42)

Remote Control, cont’d
PIP 422 and PIP 444 Picture-in-Picture Processors • Remote Control 4-6
Command/response table for SIS commands (cont’d)
Command ASCII Command Response Additional description
(host to PIP) (PIP to host)
Horizontal shift
For the image shift command, a negative (–) value is a left shift and a positive value (+) is a right
shift. To enter a negative value for the image positioning, enter a minus sign before the
X9
value.
Entry of a positive sign is optional, but not required; if no sign is included in the SIS command, the
PIP assumes a positive value. The PIP returns a negative sign in its response when the value is
negative, but does not return a positive sign.
Specific window shift value X8 * X1 * X9 H Hph1* X1 * X9 Set the window’s horizontal
positioning value to
X9 .
Example: 1*1*323H Hph1*1*323 Set window 1’s horizontal
positioning value to 323.
Example: 2*3*231H Hph2*3*231 Set the image in window 3’s
horizontal positioning value to
+231.
Increment shift up X8 * X1 +H Hph1* X1 * X9 Shift the window to the right.
Decrement shift down X8 * X1 –H Hph1* X1 * X9 Shift the window to the left.
View shift value X8 * X1 H X9 Show the window’s horizontal
positioning value.
Vertical shift
For the image shift command, a negative (–) value is an up shift and a positive value (+) is a down
shift. To enter a negative value for the image positioning, enter a minus sign before the
X10
value.
Entry of a positive sign is optional, but not required; if no sign is included in the SIS command, the
PIP assumes a positive value. The PIP returns a negative sign in its response when the value is
negative, but does not return a positive sign.
Specific shift value X8 * X1 * X10 / Vph X8 * X1 * X10 Set the vertical centering value
to
X10 .
Example: 1*2*323/ Vph1*2*323 Set window 2’s vertical
positioning value to 323.
Example: 2*4*–231/ Vph2*4*–231 Set the image in window 4’s
vertical positioning value to –231.
Increment shift down X8 * X1 +/ Vph X8 * X1 * X10 Shift down.
Increment shift up X8 * X1 –/ Vph X8 * X1 * X10 Shift up.
View shift value X8 * X1 / X10 Show the vertical centering
value.
Horizontal size
For the image size command, a negative (–) value shrinks the image and a positive value (+)
enlarges the image. To enter a negative value for the image size, enter a minus sign before the
X11
value. Entry of a positive sign is optional, but not required; if no sign is included in the SIS
command, the PIP assumes a positive value. The PIP returns a negative sign in its response when
the value is negative, but does not return a positive sign.
Specific size value X8 * X1 * X11 : Hsz X8 * X1 * X11 Set horizontal sizing to X11 .
Increment size up X8 * X1 +: Hsz X8 * X1 * X11 Make window or image wider.
Increment size down X8 * X1 –: Hsz X8 * X1 * X11 Make window or image
narrower.
View size value X8 * X1 : X11 Show horizontal sizing value.