Extron Electronics PIP 444 User Guide - Manual (Page 12)

Installation, cont’d
PIP 422 and PIP 444 Picture-in-Picture Processors • Installation 2-4
Through-desk mounting
Mount the PIP through a desk or podium as follows:
1 . Remove the feet from the underside of the PIP, if installed.
2 . Attach the supplied mounting brackets to the processor with the machine
screws provided (figure 2-1).
3 . Cut the proper sized hole in the mounting surface (figure 2-2).
Figure 2-2 — Through desk mounting a PIP
4 . Hold the processor with the attached brackets against the underside of the
table or other furniture. Mark the location of the screw holes of the bracket on
the mounting surface.
5 . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting
surface at the marked screw locations.
6 . Insert four #8 wood screws through the bracket and into the four pilot holes.
Tighten all four screws to secure the processor in place.