Extron Electronics PIP 444 User Guide - Manual (Page 20)

Operation, cont’d
PIP 422 and PIP 444 Picture-in-Picture Processors • Operation 3-2
Operation
Front Panel Features
INPUTS
1
1
2
PICTURE CONTROLS FREEZE WINDOW
PRESETS
1
2
2 PRESET ENTER WINDOW
SELECT DETAIL POSITION SIZE ZOOM MENU NEXT COL/TINT BRT/CONT SWAP
PIP 422
PICTURE-IN-PICTURE PROCESSOR
ADJUST
3 8 9 7 2 1 5 6 4
Figure 3-1 — PIP 422 front panel features
INPUTS
1
1 2
3 4
PICTURE CONTROLS FREEZE WINDOW
PRESETS
1 2
3 4
2 3 PRESET ENTER
WINDOW
SELECT DETAIL POSITION SIZE ZOOM MENU NEXT COL/TINT BRT/CONT 4
PIP 444
PICTURE-IN-PICTURE PROCESSOR
ADJUST
7 8 9 2 1 5 6 4
Figure 3-2 — PIP 444 front panel features
1 Freeze button and LEDs — Simultaneously press this button and an input
button ( 2 ) to freeze that input’s window in the displayed image.
The Freeze LED for the input lights. Repeat to unfreeze the window.
2 Input selector buttons — Press these buttons to enable or disable the inputs
for display. The LEDs next to the buttons light to indicate the inputs are
enabled.
These buttons are also used with the Freeze button ( 1 ) to toggle the freeze
function for a specific input on or off.
3 Swap button (PIP 422 only) — Press the Swap button to exchange all
window sizing, positioning, and priority settings. Press the SWAP button
again to return the windows to their previous settings.
4 Window preset buttons — Press these buttons to save or recall a preset. See
“Window Presets” later in this chapter for more information.
5 Window Select button and LEDs — Press this button to select a window to
adjust using the picture control buttons ( 6 ) and Adjust knobs ( 9 ) or using
the Input Configuration submenu. The lit LED indicates which window is
selected.