Extron Electronics PIP 444 User Guide - Manual (Page 44)

Remote Control, cont’d
PIP 422 and PIP 444 Picture-in-Picture Processors • Remote Control 4-8
Command/response table for SIS commands (cont’d)
Command ASCII Command Response Additional description
(host to PIP) (PIP to host)
Front panel lockout (Executive mode)
Lock front panel 1X Exe1 Lock front panel picture control
and menu system adjustments,
RS-232/422 adjustments only.
Unlock front panel 0X Exe0 All adjustments and selections
can be made from the front panel.
View front panel lock status X X2 Show executive mode status.
Zap (reset to default settings)
Total reset Esc zXXX ZapXXX “z” must be lower case, “XXX”
must capitalized. Reset all
settings and adjustments to the
factory defaults.
Reset all presets Esc ZG Zpg Clear all presets and their names.
Reset individual preset Esc ZG X14 Zpg X14 Clear preset X14 .
Query firmware version
General Q X16 Show the controller firmware
version.
All firmware 0Q X16
,
X16
,
X16
,
X16 Show the firmware versions for
all partitions.
Specific firmware X17 Q X16 Show the firmware version for
partition
X17 .
View build number +Q X16
.
X19 Show the firmware build
number.
Request part number
Request part number N 60-607 (606)-01 Show the PIP’s part number.
Request information
View all inputs’ video standards I X18
,
X18
,
X18
,
X18 Display each input’s video
standard. The video standards
are automatically detected; you
cannot change these entries.
View a specific input’s X1 i X18 Display the input video standard
video standard for input X1 . The video standard
is automatically detected; you
cannot change this entry.
Unsolicited report None Std X1 * X18 Display the input video standard
for input
X1 in response to a
change in input signal.
Show temperature 20S X20 F• X21 C Show the PIP’s temperature in
degrees Fahrenheit and Celsius.
The show temperature (20S) command is only available on newer model PIPs.