Extron Electronics MTPX Plus Series User Guide - Manual (Page 160)

Video input — main (see transmitters' output specifications)
Number/signal type ..................... 8, 16, or 32 proprietary analog signals
Connectors ................................. 8, 16, or 32 (depending on configuration) female RJ-45 connectors
Video output — local
Number/signal type ..................... 1 or 2 analog RGBHV, RGBS, RGsB, RsGsBs, component video (bi-level and tri-
level sync), S-video, composite video
Connectors ................................. 1 or 2 female 15-pin HD
Nominal level .............................. 0.7 Vp-p for RGB
Impedance .................................. 75 ohms ±10%
Return loss .................................. <-30 dB @ 5 MHz
DC offset .................................... <±40 mV with input at 0 offset
Video output — main (see receivers' input specifications)
Number/signal type ..................... 8, 16, or 32 proprietary analog signals
Connectors ................................. 8, 16, or 32 (depending on configuration) female RJ-45 connectors
Sync — local inputs and outputs only
Input type ................................... RGBHV, RGBS, RGsB, RsGsBs
Output type ................................ See receiver specifications (on Web site).
Standards .................................... NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level ................................... 3.5 V to 5.0 Vp-p, DC
Output level ................................ See receiver specifications (on Web site).
Input impedance ......................... 611 ohms ±5%
Output impedance ...................... 105 ohms ±30 ohms
Max. output voltage .................... =4.0 VDC with a 2k ohm load
Max. rise/fall time ........................ 4 ns
Polarity ........................................ Positive or negative
Audio
Routing
MTPX Plus 816 ................. 8 x 16 mono matrix, 3 x 4 local
MTPX Plus 128 ................. 12 x 8 mono matrix, 4 x 2 local
MTPX Plus 168 ................. 16 x 8 mono matrix, 3 x 4 local
MTPX Plus 1616 ............... 16 x 16 mono matrix, 3 x 4 local
MTPX Plus 1632 ............... 16 x 32 mono matrix, 6 x 8 local
MTPX Plus 3216 ............... 32 x 16 mono matrix, 6 x 8 local
MTPX Plus 3232 ............... 32 x 32 mono matrix, 6 x 8 local
Gain (local inputs and outputs) .... Unbalanced output: 0 dB ±2 dB with a 600 ohm load, single ended
Balanced output: +6 dB ±2 dB with a 600 ohm load, single ended
Frequency response ..................... 20 Hz to 20 kHz, ±1 dB
THD + Noise ................................ =0.15% @ 1 kHz at nominal level
S/N .............................................. >70 dB at maximum output (unweighted)
CMRR ......................................... >43 dB @ 20 Hz to 20 kHz
Audio input — local
Number/signal type ..................... 3, 4, or 6 stereo, balanced/unbalanced
Connectors ................................. (3, 4, or 6) 3.5 mm captive screw connectors, 5 pole
Impedance .................................. >10k ohms unbalanced
Nominal level .............................. +4 dBu (1.23 Vrms), -10 dBV (316 mVrms)
Maximum level ............................ +18 dBu, (unbalanced) at 1% THD+N
NOTE: 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu.
MTPX Plus Series • Reference Information 154