Extron Electronics MTPX Plus Series User Guide - Manual (Page 103)

Installing the Software
NOTE: For an MTPX Plus 128, you must use version 8.0 or newer of the Matrix
Switchers Control Program.
The program is contained on the Extron Software Products DVD. Install the software as follows:
NOTE: For full functionality, install both of the following programs:
• The Matrix Switchers Control Program
• The Firmware Loader
1. Insert the DVD into the drive. The Extron software DVD window should appear
automatically (see figure 47).
Figure 47. Software DVD Window
NOTE: If the window does not self-open, run Launch.exe from the DVD.
2. Click the Software tab (see figure 47 ).
3. Scroll to the desired program and click Install (see figure 48).
Figure 48. Software Installation
4. Follow the on-screen instructions. By default, the installation of the Matrix Switchers
Control Program creates a
C: \ Program Files \ Extron \ Matrix_Switchers
directory, and it places the following four icons into a group folder named “ Extron
Electronics \ Matrix Switchers ” :
• MATRIX Switcher + Control Program
• MATRIX Switcher + Help
• Check for Matrix Updates
• Uninstall MATRIX Switcher
MTPX Plus Series • Matrix Software 97