Performing a hard reset (reset 1), Performing a hard reset (reset 1) -30, Operation, cont’d – Extron Electronics Fiber Matrix 6400 User Manual
Page 56: Power
Operation, cont’d
Fiber Matrix 6400 Switcher • Operation
3-30
Performing a hard reset (reset 1)
The hard reset function restores the switcher to the base firmware that it was
shipped with. After a hard reset, events do not automatically start, but user settings
and files are restored. Perform a hard reset as follows:
N
The hard reset restores the factory-installed firmware. The switcher reverts to
that factory firmware the next time power is cycled off and on unless a firmware
update is performed before the power cycle.
1
.
If necessary, turn off power to the switcher.
2
.
Press and hold the Reset button on the rear panel while you apply AC power
to the switcher.
100-240V 50/60H
z
1.2A MAX.
100-240V 50/60H
z
1.2A MAX.
REDUND
ANT
PRIMAR
Y
LIN
A
TX
LINK
1
RX
LINK
2
B
TX
LIN
K
A
TX
LINK
1
RX
LINK
2
B
TX
LINK
1
RX
LINK
2
C
TX
LINK
1
ANAHEIM, CA
PRIMAR
Y PO
WER SUPP
LY
41 - 4
8
49 - 56
57 - 64
Power
RESET
RESET
Press and hold the Reset button while
you apply power to the switcher.
Release the Reset button.
Continue to hold the Reset button until all input
and output buttons are either unlit or return to
background illumination.
The switcher flashes the
button indicators light amber,
off, green, red, and amber
and then turns them off.