Extron Electronics Fiber Matrix 6400 - Manual (Page 30)

Operation, cont’d
Fiber Matrix 6400 Switcher • Operation 3-4
b
Output buttons — The output buttons have two primary functions (•) and
four secondary functions (❏):
• Select output(s).
• Identify the selected output(s).
❏ (Output 1 only) With the Input 1 button, select I/O Group mode.
See “I/O grouping” on page 3-17.
❏ Select a preset. See “Using presets” on page 3-21.
❏ Mute the output. See “Muting and unmuting outputs” on page 3-23.
❏ Output 63 — Select the RS-232 protocol for the RS-232/RS-422 port in
Serial Port Selection and Configuration mode and indicate its selection.
See “Selecting the rear panel Remote port protocol and baud rate” on
page 3-27.
❏ Output 64 — Select the RS-422 protocol for the RS-232/RS-422 port in
Serial Port Selection and Configuration mode and indicate its selection.
See “Selecting the rear panel Remote port protocol and baud rate” on
page 3-27.
Control buttons
Primary functions
Action: Save changes Select Preset mode Select View mode Cancel/escape
Indication: Blink : save needed Blink : Save preset
Lit : Recall preset
View mode selected Flashes once
ENTER PRESET VIEW ESC
Secondary functions
I/O Grouping Action/
indication:
Select group 1. Select group 2. Select group 3. Select group 4.
Port
configuration
Action 1: Select Configuration mode
Action 2/
indication: Select 9600 baud.
Blink : selected
Select 19200 baud.
Blink : selected
Select 38400 baud.
Blink : selected
Select 115200 baud.
Blink : selected
Front panel
locks
Action: With Esc, toggle
front panel lock
on and off.
Flash twice to indicated the front panel has
been locked or unlocked.
With Enter, toggle
front panel lock
on and off.
c
Enter button — The Enter button has three primary functions (•) and four
secondary functions (❏):
• Save changes that you make on the front panel. To create a simple
configuration:

Press the desired input button ( a ).

Press the desired output button(s) ( b ).

Press the Enter button.
• Indicate that a potential tie has been created but not saved.
• Indicate that a global preset has been selected to be saved or recalled but
that the preset action has not been accomplished.