Extron Electronics Fiber Matrix 6400 - Manual (Page 31)

3-5 Fiber Matrix 6400 Switcher • Operation
❏ In the I/O Group mode, select group 1 and indicate its selection.
See “I/O grouping” on page 3-17.
❏ With the Preset, View, and Esc buttons, select Serial Port Selection and
Configuration mode. See “Selecting the rear panel Remote port protocol
and baud rate” on page 3-27.
❏ Select 9600 baud for the RS-232/RS-422 port in Serial Port Selection and
Configuration mode and indicate its selection. See “Selecting the rear
panel Remote port protocol and baud rate” on page 3-27.
❏ With the Esc button, toggles the front panel lock on and off. See “Locking
out the front panel (Executive mode)” on page 3-25.
d
Preset button — The Preset button has two primary functions (•) and four
secondary functions (❏):
• Activates Save Preset mode to save a configuration as a preset and
Recall Preset mode to activate a previously-defined preset.
• Blinks when Save Preset mode is active and lights steadily when
Recall Preset mode is active.
❏ In the I/O Group mode, select group 2 and indicate its selection
See “I/O grouping” on page 3-17.
❏ With the Enter, View, and Esc buttons, select Serial Port Selection and
Configuration mode. See “Selecting the rear panel Remote port protocol
and baud rate” on page 3-27.
❏ Select 19200 baud for the RS-232/RS-422 port in Serial Port Selection and
Configuration mode and indicate its selection. See “Selecting the rear
panel Remote port protocol and baud rate” on page 3-27.
❏ With the View button, indicate that the front panel lock has been
toggled on or off. See “Locking out the front panel (Executive mode)” on
page 3-25.
e
View button — The View button has two primary functions (•) and four
secondary functions (❏):
• Select View-only mode that displays the current configuration.
N View-only mode also provides a way to mute and unmute the outputs.
See “Muting and unmuting outputs” on page 3-23.
• Indicate that View-only mode is active.
❏ In the I/O Group mode, select group 3 and indicate its selection.
See “I/O grouping” on page 3-17.
❏ With the Enter, Preset, and Esc buttons, select Serial Port Selection and
Configuration mode. See “Selecting the rear panel Remote port protocol
and baud rate” on page 3-27.
❏ Select 38400 baud for the RS-232/RS-422 port in Serial Port Selection and
Configuration mode and indicate its selection. See “Selecting the rear
panel Remote port protocol and baud rate” on page 3-27.
❏ With the Preset button, indicate that the front panel lock has been
toggled on or off. See “Locking out the front panel (Executive mode)” on
page 3-25.