Extron Electronics DMP 64 User Guide - Manual (Page 86)

8. To push all of the DSP Configurator gain and processor block adjustments
(configuration), and all presets to the DMP 64, proceed to step 9.
To tailor the push (push only the configuration, only the presets, or the configuration
and selected presets), click the
Advanced button and proceed to step 8a.
a. Select the Custom radio button.
b. Select the desired checkboxes: Push Configuration , Push Presets or both. If
Push Configuration is the only box checked, click OK and proceed to step 9.
NOTE: Push Configuration includes all mix-point, gain, and processor
block settings. It does not include partial presets.
c. If Push Presets was clicked in step 8b, click All to select all presets or
Selected to choose specific presets.
• If Selected was clicked, click OK and proceed to step 8d.
• If All was clicked (equivalent to a standard push), click OK and proceed to
step 9.
d. If Selected was clicked in step 8c, the Synchronize with Device dialog box (7b)
reappears. Click OK. The presets dialog box appears.
e. Select the desired partial presets to push by clicking the appropriate checkbox.
f. Click OK. — Proceed to step 10.
9. Click OK. The DSP Configurator program is connected live to the device, the
processors and presets are pushed or pulled as selected, and the selection of Live
mode is complete.
10. If changes were made to the DSP parameters (including mix-point, gain or processor
blocks) since the last file save, the DSP Configurator prompts to save the file. Click
Yes or No.
If a password is required and not entered or if an incorrect password is entered, the
program prompts for the password.
The configuration and presets are uploaded to the DMP 64.
DMP 64 • Software Control 80