Extron Electronics DMP 64 User Guide - Manual (Page 136)

7. Click Next (see figure 69, g on previous page). The program extracts and places the
firmware files in a folder identified in the InstallShield Wizard window.
NOTE: Write down the folder where the firmware file is saved.
8. Click Finish (see figure 69, h) to exit the program.
9. Connect the PC to the device via the Ethernet port.
10. Access the device using the HTML pages (see Download the Startup Page on
page 120 .)
11. Click the Configuration tab.
12. Click the Firmware Upgrade link.
13. Click the Browse button. An open file window appears.
14. Navigate to the folder where the firmware upgrade file was saved. Select the file.
NOTE: Valid firmware files must have the file extension ‘.S19’. Any other file
extension is not a firmware upgrade. The original factory-installed firmware is
permanently available on the device. If the attempted firmware upload fails for
any reason, the device automatically reverts to the factory-installed firmware.
15. Click Open .
16. Click Upload . The firmware upload to the device can take a few minutes.
DMP 64 • HTML Operation 130