Tools, E (see – Extron Electronics DMP 64 User Guide User Manual

Page 79

Tools

The Tools menu contains three selections:

•

Clear All Groups - clears all group members and group master parameters.

•

Increment/Decrement Simulator - allows the user to test increment/decrement
values, see below for more information.

•

Group Details Report - generates a report, listing all group masters and
membership.

Clear All Groups

Click

Tools > Clear All Groups

to delete all groups and reset all group memberships.

Soft limits are also cleared.

Increment/Decrement Simulator

The Increment/Decrement Simulator provides a control for increment and decrement, with
the ability to set increment and decrement values. This control is temporary, since the
value is not remembered in the device.
To use the Increment/Decrement Simulator:

Select

Tools > Increment/Decrement Simulator

Select the group to be controlled from the

Select Group

drop-down list. The

following dialog box appears:

Figure 50.

Increment/Decrement Simulator Dialog Box

NOTE: The

Number of Group Members:

readout indicates the number of

controls affected.

Enter an increment value and a decrement value. The default value is 1.

NOTE: The size of the increment can be changed by typing a value in the

Increment Value

Decrement Value

field. Values can be as large as the

maximum range of the control or as fine as 0.1 dB. For groups controlling mute,
1 is the only valid value.

Click the

Increment

and

Decrement

buttons as needed. The group master control

increases or decreases by the set value to the top or bottom of its soft limit range.

NOTE: When set, soft limits cannot be exceeded.

DMP 64 • Software Control