Xylem Magflux Electromagnetic Flow Meter - Manual (Page 43)

43
Electromagnetic Flow Meter
FW: 842018/842009
Initial Setup
Initial setup is normally performed by MJK personnel and is required to get
started with the MagFlux
® flow meter.
A unique sensor calibration code provides the MagFlux ® flow converter
with information about flow sensor number, nominal diameter and calibra-
tion data.
If changes to the unique sensor calibration code are needed following
physical installation and initial setup, the "Sensor Calibration Code" menu
must be addressed.
A password is not required to enter or change the sensor calibration code.
Toggle through the displayed digits with the right-arrow key when prompt-
ed for a password and press OK.
1. Press the "Setup" key on the LCD display (see below) to enter the
MagFlux ® Main Menu.
MagFlux
Flow
4.1
m 3 /h
FTot 18.77 m 3
Select Setup
2. Press the up/down keys to highlight the required menu line (here:
"Converter Setup") and then press OK to select it.
Specify Main Screen
Factory Settings
Data Logger
Password
Set Sensor Name
Converter Setup
Display Setup
Back Select OK
Main Menu
Converter Setup