YSI IQ SensorNet 2020 XT Terminal - Manual (Page 72)

Installation System 2020 XT USB
3 - 42 ba76019e01 12/2012
3.9.2 Start checklist and system start
Before starting the system, carry out the system check using the
following checklist. Always carry out the check
 before the initial commissioning
 before any further commissioning if the system has been previously
extended or modified.
Starting the system Switch on the voltage supply of the MIQ power supply module(s).
Start checklist
1 Is the sum of the power consumption of the components
smaller than the sum of the power delivery of all power supply
modules (see section 3.3)?
2 Are all IQ S ENSOR N ET components correctly connected with
one another (see section 3.5)?
3 Are all SN terminator switches correctly set (see section
3.9.1)?
4 Is the MIQ power supply module correctly connected to the
voltage supply?
5 Do the line voltage and line frequency agree with the data on
the name plate of the MIQ power supply module?
6 Are all IQ sensors ready for measuring, e.g. a D.O. sensor
filled with electrolyte solution?