YSI IQ SensorNet 2020 XT Terminal - Manual (Page 22)

Overview System 2020 XT USB
1 - 16 ba76019e01 12/2012
1.3.4 USB interface
The USB interface of the MIQ/TC 2020 XT provides the following
functions:
 Connection of a USB memory device for data transmission (see
section 4.9)
– Measurement data
– Calibration data
– Configuration data
– Log book
 Connection of a PC for data transmission or for control via the MIQ/
T2020 PC software terminal (see operating manual ba64108
"IQ S
ENSOR N ET Softwarepack"). The various connection options
(direct connection, modem, network etc.) are described in the
operating manual ba75790 "Remote connection to the
IQ S
ENSOR N ET 2020 XT USB".
 Connection of an electronic key for simple system access with
enabled access control (see section 5.4.2)
 Connection of a USB hub to multiply the USB interface
Note
The USB interface is equipped with a protective cover.
Only remove the protective cover if you want to connect a USB device.
Close the connection immeditaley after disconnecting the USB device.
If the USB connection remains open there is the risk of corrosion.
Operation of the
MIQ/TC 2020 XT
in the open
Do not leave any USB devices permanently connected to the USB
interface. There is the risk of corrosion.