YSI IQ SensorNet 2020 XT Terminal - Manual (Page 142)

Settings/setup System 2020 XT USB
5 - 22 ba76019e01 12/2012
5.7.2 Erasing a Sensor-sensor link
Note
The Sensor-sensor link function is automatically deactivated if the
measured parameter of the linked sensor is changed (e.g. by switching
the display of the TetraCon
®
700 IQ conductivity sensor from salinity to
conductivity).
1 Using , open the Settings menu.
2 Using < ><> and , select and confirm the menu item,
System settings -> Sensor-sensor link.
The Sensor-sensor link overview opens.
The displayed list includes all sensors with which the
correction of an influence quantity is possible (e.g. FDO
®
700
IQ).
3 Using <
><>, highlight a sensor and confirm with .
The displayed list includes all linked sensors.
4 Using <
><>, highlight a sensor and confirm with .
The displayed list includes all sensors that measure an
influence quantity with the correct unit
(e.g. TetraCon
®
700 IQ, which measures the salinity in mg/L),
and the menu item, Erase link.
5 Using <
><>, highlight the menu item, Erase link, and
confirm with .
The sensor-sensor link is deleted.
6 Leave the system settings with .
In the measured value display, the measured value is
corrected by the manually entered value.