GE Industrial Solutions Millennium II Controller J85501P-1 - Manual (Page 23)

Basic Installation and User’s Guide for the Millennium II Controller
Issue 3 January 2008 23
Controller Connections
Figure 4-2: Millennium II Controller Connections
Table 4-A: Millennium II Interface Reference
Interface
Reference Description
P1 Connectorized interface for large parallel format 8x40 LCD assembly
P2 10/100 Base-T LAN/Ethernet interface
P3 Connectorized interface for 10K/30K thermistor probe options or 210E
P6 Connectorized input for input power, monitoring of two shunts, plant sense voltage, and
Major Fuse alarm (Same connection as on the Millennium)
P7 RJ45 receptacle for ground referenced Auxiliary RS485 circuit and One-Wire temperature
monitoring devices
P8 BSL1-4 circuit pack Interface connector for Input/Output to controller
P9 RJ45 receptacle for isolated RS485 system component monitoring and control of rectifiers,
converters, low voltage disconnect contactors, and bay level alarm inputs (Serial Rectifier
bus)
P13 Factory test connector (not used in the field)
P14 Connectorized interface for future smaller serial format LCD
P15 Connectorized interface for future smaller serial format LCD
P201 Connectorized interface for optional Modem
P202 Ground referenced DB-9 for local RS232 serial port
P205 Option board connector
TB1 Terminal block interface for RS232/RS485 Auxiliary port and Remote Peripheral Module
(RPM) connections
TB2 Terminal block interface for three additional 10K thermistor probe or 210E connection
options
J10 USB interface (reserved for future use)