Rainbow Electronics ATmega64L - Manual (Page 70)

70
ATmega16(L)
2466B–09/01
OCR0 compare register to either top or bottom of the counting sequence. The synchro-
nization prevents the occurrence of odd-length, non-symmetrical PWM pulses, thereby
making the output glitch-free.
The OCR0 register access may seem complex, but this is not case. When the double
buffering is enabled, the CPU has access to the OCR0 buffer register, and if double
buffering is disabled the CPU will access the OCR0 directly.
Force Output Compare In non-PWM waveform generation modes, the match output of the comparator can be
forced by writing a one to the force output compare (FOC0) bit. Forcing compare match
will not set the OCF0 flag or reload/clear the timer, but the OC0 pin will be updated as if
a real compare match had occurred (the COM01:0 bits settings define whether the OC0
pin is set, cleared or toggled).
Compare Match Blocking by
TCNT0 Write All CPU write operations to the TCNT0 register will block any compare match that occur
in the next timer clock cycle, even when the timer is stopped. This feature allows OCR0
to be initialized to the same value as TCNT0 without triggering an interrupt when the
Timer/Counter clock is enabled.
Using the Output Compare
Unit Since writing TCNT0 in any mode of operation will block all compare matches for one
timer clock cycle, there are risks involved when changing TCNT0 when using the output
compare channel, independently of whether the Timer/Counter is running or not. If the
value written to TCNT0 equals the OCR0 value, the compare match will be missed,
resulting in incorrect waveform generation. Similarly, do not write the TCNT0 value
equal to BOTTOM when the counter is downcounting.
The setup of the OC0 should be performed before setting the data direction register for
the port pin to output. The easiest way of setting the OC0 value is to use the force output
compare (FOC0) strobe bits in normal mode. The OC0 register keeps its value even
when changing between waveform generation modes.
Be aware that the COM01:0 bits are not double buffered together with the compare
value. Changing the COM01:0 bits will take effect immediately.
Compare Match Output
Unit The compare output mode (COM01:0) bits have two functions. The waveform generator
uses the COM01:0 bits for defining the output compare (OC0) state at the next compare
match. Also, the COM01:0 bits control the OC0 pin output source. Figure 30 shows a
simplified schematic of the logic affected by the COM01:0 bit setting. The I/O registers,
I/O bits, and I/O pins in the figure are shown in bold. Only the parts of the general I/O
port control registers (DDR and PORT) that are affected by the COM01:0 bits are
shown. When referring to the OC0 state, the reference is for the internal OC0 register,
not the OC0 pin. If a system reset occur, the OC0 register is reset to “0”.