Rainbow Electronics AT86RF211 - Manual (Page 39)

39
AT86RF211
1942C–WIRE–06/02
The data rate (in bps) and the decimal value to be coded in the register are related by
the equation:
The following table gives the programming values of commonly used rates:
Wake Up Address Register
(WUA)
Concerning this register, attention should be paid to the fact that the last bit of the
address field is not taken into account when testing the address field that is received.
Thus the last bit must be programmed and counted in the address length but it can be
either "0" or "1".
Rate WUR RATE
1200 bits/sec (533)
10
2400 bits/sec (267)
10
4800 bits/sec (133)
10
9600 bits/sec (67)
10
RATE
640000
rate (bps)
------------------------- =
Table 21. WUA Overview
Name ADDL ADD
nbit 24-20 19-0
init (01001)
2
(0f0f0)
16
Table 22. WUA Detailed Description
Name Number of bits Comments
ADDL 5 Wake-up address length
0: wake-up address length = 1 bit
1: wake-up address length = 2 bits
..........
(19)
10
: wake-up address length = 20 bits
>(19)
10
: forbidden
reset value: 10 bits
ADD 20 Wake-up address
If wake-up address length is less than 20 bits, MSB bits are ignored
reset value: (0f0f0)
16