Rainbow Electronics ATmega8515L - Manual (Page 178)

178
ATmega8515(L)
2512A–AVR–04/02
Parallel Programming
Parameters, Pin
Mapping, and
Commands This section describes how to parallel program and verify Flash Program memory,
EEPROM Data memory, Memory Lock bits, and Fuse bits in the ATmega8515. Pulses
are assumed to be at least 250 ns unless otherwise noted.
Signal Names In this section, some pins of the ATmega8515 are referenced by signal names describ-
ing their functionality during parallel programming, see Figure 74 and Table 85. Pins not
described in the following table are referenced by pin names.
The XA1/XA0 pins determine the action executed when the XTAL1 pin is given a posi-
tive pulse. The bit coding is shown in Table 87.
When pulsing WR or OE, the command loaded determines the action executed. The dif-
ferent Commands are shown in Table 88.
Figure 74. Parallel Programming
Table 85. Pin Name Mapping
Signal Name in Programming Mode Pin Name I/O Function
RDY/BSY PD1 O
0: Device is busy programming, 1:
Device is ready for new command
OE PD2 I Output Enable (Active low)
WR PD3 I Write Pulse (Active low)
BS1 PD4 I
Byte Select 1 (“0” selects low
byte, “1” selects high byte)
XA0 PD5 I XTAL Action Bit 0
XA1 PD6 I XTAL Action Bit 1
PAGEL PD7 I
Program Memory and EEPROM
data Page Load
BS2 PA0 I
Byte Select 2 (“0” selects low
byte, “1” selects 2’nd high byte)
DATA PB7-0 I/O
Bi-directional Data bus (Output
when OE is low)
VCC
+5V
GND
XTAL1
PD1
PD2
PD3
PD4
PD5
PD6
PB7 - PB0 DATA
RESET
PD7
+12 V
BS1
XA0
XA1
OE
RDY/BSY
PAGEL
PA0
WR
BS2