M&C TechGroup SP2000H_DIL_BR Operator's manual - Manual (Page 15)

15
Gas sampling and gas conditioning technology 2-1.1.7-ME
10 DIMENSIONS
The dimensions of the SP2000H/DIL/2x probes are shown below.
Power
230V,50Hz
(115V,60Hz)(a)
Low temperature
alarm contact
Sample out Dil gas
8x1mm  o
Tube Tube
6x1mm  o
Tube
Sample
diluted
Pressure gauge
-
1…0bar
Cal gas Dil gas
Tube 8x1mm * (Inj. I)
Sample out
undiluted
1/4"NPT
Dil gas in
6x1mm  o
Tube
6x1mm  o
260
345 340
1) Implementation of the cal gas valve only with 180°C version; With 320°C version assembling in the angular sheet.
2)
Tube connection 8mm (3/8”) 
o; With injector I connection DN6/8mm or DN8/10mm and with injector II DN8/10mm-DN12/14mm.
1)
2)
Figure 7 Dimensions (mm) of SP2000H/DIL probe
11 RECEIPT AND STORAGE

Carefully remove the probe and any accessories from the transport packaging immediately upon
receipt and check the delivery against the delivery note.

Check the contents for possible transport damage and immediately notify the transport insurer of
any damage.
N O T E !
The probe should be stored in a protected, frost-free room.
12 INSTALLATION INFORMATION
The safety rules and regulations for the prevention of accidents must be observed during installation
and also subsequent operation. The information in C
hapter 3‚ “Important safety information” must be
observed.
The following also applies:

Select the optimal sampling point according to the generally applicable directives or co-ordinate
with the responsible departments.