EVS IPDirector Version 6.2 - June 2013 GENERAL FUNCTIONS User Manual - Manual (Page 125)

• any target destination visible on the GigE network that has been defined in the
Remote Installer (CleanEdit targets, Avid targets, Final Cut Pro targets, File targets,
XT targets).
• the EVS servers for which the user has visibility right
• the bins configured in IPDirector and for which the user has write access right.
8.4.4. BEPlay Remote Buttons
Function Buttons
Function buttons are used to control a recorder or a player channel, or the Software
Player. The section "Assigning Channels to Function Buttons" on page 119 describes the
possible ways to assign channels to function buttons.
The LED of a function button gives indication on the channel assignment.
The LED of a
Function
button…
…when
is green a player channel or the Software Player is assigned to the button
flashes green the player channel or the Software Player assigned to the button
is being controlled by the Remote
is red a recorder channel is assigned to the button
flashes red the record train from the recorder channel assigned to the button
is loaded on the player controlled by the Remote
is not turned on • no channel is assigned to the button, or
• the user cannot see the recorder channel or control the player
channel, or
• the Software Player is not opened.
Action Buttons
The BEPlay Remote has 14 buttons which can all be used to perform specific actions.
Those actions will depend on several conditions:
• the SHIFT key is pressed before the button or not
• the Layout selected from the Remote Control Manager window
• the media type (clip, playlist, train, playlist element or timeline) loaded on the channel
controlled by the remote.
The following table gives a brief description of the action of each action button. The media
types on which the action button has an effect are mentioned in bold in the Description
column.
IPDirector - Version 6.2 - User Manual - General Functions
8. Remote Control Management 113