EVS XEDIO CleanEdit Version 4.1 - December 2011 User Manual - Manual (Page 143)

Xedio Suite Version 4.1 – User’s Manual – CleanEdit
EVS Broadcast Equipment – December 2011
Issue 4.1.B
129
Example
In the example below, you work in Overwrite mode and want to extend the IN point
of the clip called ‘Clip3’.
To do this, you select the clip to be extended and place a mark IN where you want
the IN point of the clip to be extended to.
The screenshot below shows the extended clip:
H
OW TO
E
XTEND OR
S
HORTEN A
C
LIP
U
SING A
D
RAG
O
PERATION
To extend or shorten selected elements or a clip on the IN or OUT point using a
drag operation, proceed as follows:
1. If required, change the Overwrite or Insert mode clicking the button.
2. Select the elements or clip to be extended or shortened.
3. Position the mouse cursor over the 3 lines symbol near the IN or OUT point of
the clip and drag the clip edge to the required position on the timeline.
4. Release the mouse.
Example
In the example below, you work in Overwrite mode and want to extend the OUT
point of the clip called ‘Clip3’.