3Com TR - Manual (Page 86)

5-4 C HAPTER 5: C ONFIGURING WITH THE LCD C ONSOLE
4 Press [Down Arrow] until Port # >Link State appears.
5 Press [Enter].
Link State # >[state] appears.
The Link State identifies the current state of the port
you are viewing.
■ Disabled
■ Blocking
■ Listening
■ Learning
■ Forwarding
■ Broken
This read-only field cannot be changed.
6 Press [Left Arrow] to return to previous menu.
Setting Port State
From the Switch 2000 TR>Unit Id # LCD banner, pro-
ceed as follows:
1 Press [Enter].
Switch 2000 TR >Unit appears.
2 Press [Down Arrow] until Switch 2000 TR >Port
appears.
3 Press [Enter].
4 Press [Down Arrow] until Port # >Port State appears.
5 Press [Enter].
Port State # >[state] appears.
The Port State identifies the current state of the port
you are viewing.
6 Press [Down Arrow] to select the state. Choices:
■
Enable
■
Disable
7 Press [Enter] to confirm the state.
If you select Disable, the LED for the corresponding
port lights yellow to show the current state.
Setting Speed
From the Switch 2000 TR>Unit Id # LCD banner, pro-
ceed as follows:
1 Press [Enter].
Switch 2000 TR >Unit appears.
2 Press [Down Arrow] until Switch 2000 TR >Port
appears.
3 Press [Enter].
4 Press [Down Arrow] until Port # >Speed appears.
5 Press [Enter].
Speed # [speed] appears.
Press [Down Arrow] to select speed. Choices:
■
16 MB
■
4 MB
6 Press [Enter] to confirm the speed setting.
7 Press [Left Arrow] to return to the previous menu.