3Com TR - Manual (Page 61)

Bridge Configuration 4-3
Bridge Configuration
The bridge configuration section includes information
on the following:
■ Source Routing Transparent (SRT)
■ Source Route (SR)
■ Transparent (TP)
■
Spanning Tree Fields
Setting Source Routing Transparent (VT100)
NOTE: This bridge setting requires that you reset the
switch. Refer to “Resetting the Switch 2000 TR in
Chapter 3 for instructions.
1 Log on to the Switch 2000 TR.
2 Select Switch Management from the Main Menu.
3 Press [Space Bar] and select *Bridge*.
4 Select SETUP. The TR Bridge Setup screen appears.
Figure 4-4 TR Bridge Setup Screen
5 Select OK.
6 Select *SRT*. Press [Space Bar] to change.
7 Press [Return].
8 Select *IBM*, *802.1d*, or *disabled* in the Span-
ning Tree Support field. A BPDU value is automatically
assigned:
■ 802.1d Spanning Tree—80-01-43-00-00-00
■ IBM Spanning Tree—C0-00-00-00-01-00
9 Assign a Bridge Number. Enter in Hex. Choose from 0
to f.
10 Select OK.
11 From the Main Menu, press [Space Bar] until *Port*
appears. Select the proper unit and port ID to config-
ure.
12 Select SETUP. The TR Port Setup screen appears. See
Figure 4-5.
Figure 4-5 TR Port Setup Screen