I/o module configuration, Stack configuration, Setting up the stack – 3Com TR User Manual
Page 69: I/o module configuration 4-11, Stack configuration 4-11, Setting up the stack 4-11
I/O Module Configuration
4-11
■
Forced— Indicates that the port will always
accept and propagate STE packets.
■
Auto-Span—Indicates that the port will accept
and propagate STE packets when its Spanning
Tree state is forwarding.
NOTE:
Spanning Tree does not have to be enabled for
this to function correctly.
4
Select OK to save changes.
I/O Module Configuration
I/O Module configuration allows you to set up for the
following module options:
■
FDDI
■
ATM
■
TR-in-FE
For detailed information on configuring your module
option, see their respective manuals:
■
SuperStack II Switch 2000 TR ATM OC-3 Module
User Guide
■
SuperStack II Switch 2000 TR FDDI Module User
Guide
■
SuperStack II Switch 2000 TR TR-in-FE Module
User Guide
Stack Configuration
Stack configuration allows you to set these stack
attributes:
■
sysName
■
BootP Client
NOTE:
All settings in the Stack Setup screens are
“live” settings. They take effect immediately.
For more information on the stack, refer to “Stack
Status in Chapter 6.
Setting Up the Stack
1
Log on to the Switch 2000 TR.
2
Select Switch Management from the Main Menu.
3
Press [Space Bar] and select *Stack*.
4
Select SETUP. The TR Stack Setup screen appears. See
Figure 4-9.
Figure 4-9 TR Stack Setup Screen