3Com TR - Manual (Page 81)

Serial Port Configuration 4-23
minal’s serial port parameters match those on the
Switch 2000 TR. This allows you to continue to access
the management facility from the equipment after
you change the serial port parameters.
The Serial Port Setup screen displays the following:
Connection Type
Local/remote Select Remote if you wish to manage
the Switch 2000 TR using a modem; DCD Control
and DSR Control will be enabled. For all other cases
this should remain at Local.
DCD Control
Enabled/Disabled This field applies to local con-
nection types. This determines if DCD needs to be
asserted for remote connection and if the connection
requires that DCD be released. Refer to your terminal
or modem documentation for more information.
DSR Control
Enabled/Disabled This field applies only to local
connection types. This determines if DSR needs to be
asserted for remote connection and if the connection
requires that DSR be released. Refer to your terminal
or modem documentation for more information.
Flow Control
XON/XOFF/NONE/RTS-CTS
Unidirectional/RTS-CTS Bidirectional
Select the
correct flow control option for your terminal or
modem. Refer to your terminal or modem documen-
tation for more information.
Auto Config
Enabled/Disabled The Switch 2000 TR can
auto-configure the line speed (baud) to work with
your VT100-compatible terminal.
Speed
1200/2400/9600/19200 Select the correct line
speed (baud) for your terminal or modem.
Char Size
8 Displays the character bit size for the Switch 2000
TR. You should set your terminal to the same value.
Parity
NONE Displays the parity setting for the Switch
2000 TR. You should configure your terminal to the
same setting.
Stop Bit
1 Displays the Stop Bit setting for the Switch 2000
TR. You should configure your terminal to the same
setting.