ZyXEL Communications GS-2724 - Manual (Page 285)

Chapter 41 Interface Commands
GS-2724 User’s Guide
285
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Enable ingress checking on the ports.
• Enable tagged frame-types on the interface.
41.2.9 weight
Syntax:
weight ...
where
An example is shown next.
• Enable WRR queuing on ports 2 and 6 to 8.
• Enable port 2 and ports 6 to 8 for configuration.
• Set the queue weights from Q0 to Q7.
41.2.10 egress set
Syntax:
egress set
where
An example is shown next.
• Enable port-based VLAN tagging on the Switch.
• Enable ports one, three, four and five for configuration.
untagged> = Choose to accept both tagged and untagged incoming frames, just
tagged incoming frames or just untagged incoming frames on a port.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# ingress-check
sysname(config-interface)# frame-type tagged
...
= Sets the interface WFQ weighting. A weight value of one to eight is
given to each variable from wt 1 to wt 8 .
sysname# configure
sysname(config)# interface port-channel 2,6-8
sysname(config-interface)# wrr
sysname(config-interface)# weight 8 7 6 5 4 3 2 1
= Sets the outgoing traffic port list for a port-based VLAN.