ZyXEL Communications GS-2724 - Manual (Page 268)

Chapter 39 User and Enable Mode Commands
GS-2724 User’s Guide
268
39.6.1 Using a Different Configuration File
You can store up to two configuration files on the Switch. Only one configuration file is used
at a time. By default the Switch uses the first configuration file (with an index number of 1).
You can set the Switch to use a different configuration file. There are two ways in which you
can set the Switch to use a different configuration file: restart the Switch (cold reboot) and
restart the system (warm reboot).
Use the
boot config command to restart the Switch and use a different configuration file (if
specified). The following example restarts the Switch to use the second configuration file.
Use the reload config command to restart the system and use a different configuration file
(if specified). The following example restarts the system to use the second configuration file.
"
When you use the
write memory
command without specifying a configuration
file index number, the Switch saves the changes to the configuration file the
Switch is currently using.
39.6.2 Resetting to the Factory Default
Follow the steps below to reset the Switch back to the factory defaults.
1 Enter erase running config to reset the current running configuration.
2 Enter write memory to save the changes to the current configuration file. If you want
to reset the second configuration file, use the write memory command again with the
specified index number.
The following example resets both configuration files to the factory default settings.
sysname# boot config 2
sysname# reload config 2
sysname# erase running-config
sysname# write memory
sysname# write memory 2