ZyXEL Communications GS-2724 - Manual (Page 255)

Chapter 38 Introducing Commands
GS-2724 User’s Guide
255
38.11.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
Table 91 interface port-channel Commands
COMMAND DESCRIPTION
PRIVILEG
E
interface
port-
channel
list> Enables a port or a list of ports for
configuration.
13
bandwidth-limit Enables ingress (pir), cir and
egress limits on the port(s).
13
cir Enables the guaranteed
bandwidth limits for incoming
traffic on the port(s).
13
cir Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
pir Enables bandwidth limits allowed
for incoming traffic on the port(s).
13
pir Sets the maximum bandwidth
allowed for incoming traffic on the
port(s).
13
egress Enables bandwidth limits allowed
for outgoing traffic on the port(s).
13
egress Sets the maximum bandwidth
allowed for outgoing traffic on the
port(s).
13
bpdu-control
ard|network> Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
13
broadcast-limit Enables broadcast storm control
limit on the port(s).
13
Specifies the maximum number of
broadcast packets to allow
through the port.
13
diffserv Enables DiffServ on the port(s). 13
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
13
Sets the interface DLF limit in
packets per second (pps).
13
egress set list> Sets the outgoing traffic port list
for a port-based VLAN.
13
exit Exits from the interface port-
channel command mode.
13
flow-control Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
13