3 the login screen, 4 command syntax conventions, 3 the login screen 38.4 command syntax conventions – ZyXEL Communications GS-2724 User Manual
Page 230

Chapter 38 Introducing Commands
GS-2724 User’s Guide
230
• VT100 terminal emulation
• 9600 bps
• No parity
• 8 data bits
• 1 stop bit
• No flow control
38.2.1.1 Initial Screen
When you turn on your Switch, it performs several internal tests as well as line initialization.
You can view the initialization information using the console port. After the initialization, the
login screen displays (refer to
Use the following steps to Telnet into your Switch.
1 For local management, connect your computer to the RJ-45 management port (labeled
MGMT) on the Switch.
2 Make sure your computer IP address and the Switch’s IP address are on the same subnet.
In Windows, click Start (usually in the bottom left corner), Run and then type
telnet
192.168.0.1
(the default management IP address) and click OK.
3 A login screen displays (refer to
38.3 The Login Screen
After you have successfully established a connection to the Switch using a direct console
connection or Telnet, a login screen displays as shown below. For your first login, enter the
default administrator login username “admin” and password “1234”.
38.4 Command Syntax Conventions
The rules of the commands are listed next.
• The command keywords are in
courier new font
.
Copyright (c) 1994 - 2006 ZyXEL Communications Corp.
initialize mgmt, ethernet address: 00:13:49:00:00:01
initialize switch, ethernet address: 00:13:49:00:00:02
Initializing switch unit 0...
Initializing VLAN Database...
Initializing IP Interface...
Initializing Advanced Applications...
Initializing Command Line Interface...
Initializing Web Interface...
Press ENTER to continue...
Enter User Name : admin
Enter Password : XXXX