Figure 99 logins, Table 71 logins – ZyXEL Communications GS-2724 User Manual
Page 197

Chapter 29 Access Control
GS-2724 User’s Guide
197
From the Access Control screen, display the Logins screen. You can click Access Control to
go back to the Access Control screen.
Figure 99 Logins
The following table describes the labels in this screen.
Table 71 Logins
LABEL
DESCRIPTION
Administrator
This is the default administrator account with the “admin” user name. You cannot change the default
administrator user name. Only the administrator has read/write access.
Old Password
Type the existing system password (1234 is the default password when
shipped).
New Password
Enter your new system password.
Retype to confirm Retype your new system password for confirmation
Edit Logins
You may configure passwords for up to four users. These users have read-only access. You can give
users higher privileges via the CLI. For more information on assigning privileges see
.
User Name
Set a user name (up to 32 ASCII characters
long).
Password
Enter your new system password.
Retype to confirm Retype your new system password for confirmation
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Cancel
Click Cancel to reset the fields.