ZyXEL Communications GS-2724 - Manual (Page 209)

Chapter 31 Syslog
GS-2724 User’s Guide
209
Figure 111 Syslog Server Setup
The following table describes the labels in this screen.
Table 77 Syslog Server Setup
LABEL DESCRIPTION
Active Select this check box to have the device send logs to this syslog server. Clear the
check box if you want to create a syslog server entry but not have the device send
logs to it (you can edit the entry later).
Server Address Enter the IP address of the syslog server.
Log Level Select the severity level(s) of the logs that you want the device to send to this
syslog server. The lower the number, the more critical the logs are.
Add Click Add to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to reset the fields.
Clear Click Clear to return the fields to the factory defaults.
Index This is the index number of a syslog server entry. Click this number to edit the
entry.
Active This field displays Yes if the device is to send logs to the syslog server. No
displays if the device is not to send logs to the syslog server.
IP Address This field displays the IP address of the syslog server.
Log Level This field displays the severity level of the logs that the device is to send to this
syslog server.
Delete Select an entry’s Delete check box and click Delete to remove the entry.
Cancel Click Cancel to reset the fields.