ZyXEL Communications GS-2724 User Manual
Page 275
Chapter 40 Configuration Mode Commands
GS-2724 User’s Guide
275
where
An example is shown next.
• Disable authentication on the Switch.
• Disable re-authentication on ports one, three, four and five.
• Disable authentication on ports one, six and seven.
Figure 124 no port-access-authenticator Command Example
40.5.4.3 no ssh
Syntax:
no ssh key
no ssh known-hosts
no ssh known-hosts
where
An example is shown next.
• Disable the secure shell RSA1 encryption key.
• Remove the remote host with IP address 172.165.1.8 from the list of known hosts.
• Remove the remote host with IP address 172.165.1.9 and with an SSH-RSA encryption
key from the list of known hosts.
=
Disables port authentication on the Switch.
reauthenticate
=
Disables the re-authentication mechanism on the listed port(s).
=
Disables authentication on the listed ports.
sysname(config)# no port-access-authenticator
sysname(config)# no port-access-authenticator 1,3-5 reauthenticate
sysname(config)# no port-access-authenticator 1,6-7
key
=
Disables the secure shell server encryption key. Your Switch
supports SSH versions 1 and 2 using RSA and DSA
authentication.
known-hosts
=
Removes a specific remote host from the list of all known
hosts.
known-hosts
[1024|ssh-rsa|ssh-dsa]
=
Removes remote known hosts with a specified public key
type (1024-bit RSA1, RSA or DSA).
sysname(config)# no ssh key rsa1
sysname(config)# no ssh known-hosts 172.165.1.8
sysname(config)# no ssh known-hosts 172.165.1.9 ssh-rsa