ZyXEL Communications GS-2724 - Manual (Page 259)

Chapter 38 Introducing Commands
GS-2724 User’s Guide
259
38.11.6 config-vlan Commands
The following table lists the vlan commands in configuration mode.
igmp query-interval Sets the igmp query interval on
the Switch. This variable
specifies the amount of time in
seconds between general query
messages sent by the router.
13
igmp query-max-
response-time <1-25> Sets the maximum time that the
router waits for a response to an
general query message.
13
igmp last-member-
query-interval <1-25> Sets the amount of time in
seconds that the router waits for
a response to a group specific
query message.
13
rip direction
th|None> version
Sets the RIP direction in this
routing domain as well as the
version number.
13
no ip igmp Disables IP IGMP in this routing
domain.
13
Table 92 interface route-domain Commands (continued)
COMMAND DESCRIPTION
PRIVILEG
E
Table 93 Command Summary: config-vlan Commands
COMMAND DESCRIPTION
PRIVILEG
E
vlan
Creates a new VLAN group. 13
exit Leaves the VLAN configuration
mode.
13
fixed Specifies the port(s) to be a
permanent member of this VLAN
group.
13
forbidden list> Specifies the port(s) you want to
prohibit from joining this VLAN
group.
13
help Displays a list of available VLAN
commands.
13
inactive Disables the specified VLAN. 13
ip address Sets the IP address of the
Switch in the VLAN.
13
manageable Sets the IP address of the
Switch in the VLAN and allow
remote management to this IP
address.
13
default-gateway address> Sets the default gateway IP
address in this VLAN.
13
name Specifies a name for
identification purposes.
13