Interface commands, 1 overview, 2 interface command examples – ZyXEL Communications GS-2724 User Manual
Page 281: 1 interface port-channel, 2 bpdu-control, Chapter 41 interface commands, 1 overview 41.2 interface command examples, 1 interface port-channel 41.2.2 bpdu-control, Interface commands (281)

GS-2724 User’s Guide
281
C
H A P T E R
41
Interface Commands
These are some commonly used configuration commands that belong to the
interface
group of commands.
41.1 Overview
The interface commands allow you to configure the Switch on a port by port basis.
41.2 Interface Command Examples
This section provides examples of some frequently used interface commands.
41.2.1 interface port-channel
Use this command to enable the specified ports for configuration. Indicate multiple, non-
sequential ports separated by a comma. Use a dash to specify a port range.
Syntax:
interface port-channel
An example is shown next.
• Enter the configuration mode.
• Enable ports 1, 3, 4 and 5 for configuration.
• Begin configuring for those ports.
41.2.2 bpdu-control
Syntax:
bpdu-control
sysname# config
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)#