Yamaha WC42260 - Manual (Page 97)

Using Surround Pan
97
DM2000 Version 2—Owner’s Manual
Using Surround Pan
The DM2000 supports 3-1, 5.1 and 6.1 Surround modes. Surround pan is independent of
normal panning. Normal panning determines how the Input Channel signal is panned
between the left and right channels of the Stereo out. Whereas surround panning deter-
mines how the Input Channel signal is panned among the Surround channels (i.e., the Bus
Outs).
If Input Channel Follow Pan is off, you can patch signals to the corresponding Bus Outs
without being affected by the surround pan setting. This is useful when you want to assign
the surround source or surround effect return to Bus Outs.
When the Nominal Pan preference is on (see page 275), signals will be at nominal level
when panned hard left or hard right, and at +3 dB when the preference is turned off.
The following table shows how Surround channels are handled by the Bus Outs.
The table may vary depending on the settings on the Surround Bus Setup page (see
page 99).
Selecting Surround Pan Modes
The Surround mode can be selected as follows.
1 Use the SELECTED CHANNEL PAN/SURROUND [DISPLAY] button to select
the Surround Mode page.
Note: If you have saved a scene with the Follow Pan function turned off on a DM2000 that is
older than Version 2.0, the surround setting may not be reproduced
Surround
Mode
Bus Outs
1 2 3 4 5 6 7
3-1
L R C S
— — —
Front left Front right Center Surround
5.1
L R Ls Rs C LFE
—
Front left Front right Rear left Rear right Center Subwoofer
6.1
L R Ls Rs C Bs LFE
Front left Front right Rear left Rear right Center Rear center Subwoofer