Yamaha WC42260 - Manual (Page 263)

About Machine Control (MMC & P2)
263
DM2000 Version 2—Owner’s Manual
2 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
MACHINE CONTROL/DAW CONTROL: When the MACHINE CONTROL option is
on, the MACHINE CONTROL section controls external MMC or P2 machines, regardless
of the layer selection. When the DAW CONTROL option is on, the MACHINE CONTROL
section controls DAWs, regardless of the layer selection.
MACHINE: This parameter is used to specify the Master machine whose track is to be
armed when each TRACK ARMING button is pressed. Only machines configured as Mas-
ters on the Machine Configuration page (see page 256) can be selected.
TARGET TRACK: This parameter is used to specify the Master machine track that is to be
armed when each TRACK ARMING button is pressed.
Configuring Track Arming Groups
Track arming groups A, B, C, and D provide a quick way to arm multiple MTR or Master
machine tracks.
1 Use the TRACK ARMING [DISPLAY] button to locate the Track Arming Group
page.
2 Use the cursor buttons or Parameter wheel to select the track buttons, and
use the INC/DEC buttons or [ENTER] button to add and remove tracks from
the groups.
A track is in a group when its button appears highlighted, and tracks can be in multiple
groups. The CLEAR buttons can be used to clear all assignments in each group.
When a TRACK ARMING GROUP [A–D] button is pressed, that button’s indicator, and
the button indicators of the tracks in that group light up. If one of those tracks is subse-
quently unarmed, the TRACK ARMING GROUP [A–D] button indicator goes out.
MACHINE CONTROL/DAW CONTROL: When the MACHINE CONTROL option is
on, the MACHINE CONTROL section controls external MMC or P2 machines, regardless
of the layer selection. When the DAW CONTROL option is on, the MACHINE CONTROL
section controls DAWs, regardless of the layer selection.