Yamaha WC42260 - Manual (Page 278)

278
Chapter 21—Other Functions
DM2000 Version 2—Owner’s Manual
Receive Full Frame Message: When this preference is on, MTC full frame messages
are recognized and Automix follows them.
Touch Sense Edit In All: When this preference is on, using the faders’ Touch Sense
function enables you to punch in and out all parameters for which the corresponding
OVERWRITE buttons are turned on. When this preference is off, you can punch in and out
only these faders selected in Fader mode.
Show Compact Size: Automix data, except that in the Undo buffer, is compressed while
recording. When this preference is on, the compressed size of the Automix is displayed on
the Automix Memory pages. When this preference is off, the uncompressed size is dis-
played.
Automix Store Undo: When this preference is on, Automix Store operations can be
undone by using the Undo function.
Drop Out Time: This parameter sets an interval (in frames) between the interruption of
incoming timecode and the stoppage of Automix recording or playback.
Lock Time: This parameter sets the interval (in frames) allowed until the Automix locks
to incoming timecode messages. If the sync operation is unstable, set this value higher.
Frame Jump Error: This parameter sets the time interval (in frames) required by the
DM2000 to recognize an error after incoming timecode messages jump. If the actual inter-
val is shorter than the value specified by this parameter, the DM2000 continues the sync
operation. If the frame jump causes the recording or playback to stop during the MTC and
SMPT sync operation, set the parameter value higher than the number of frames indicated
in the error message.
If you set the parameter to a higher value, adjust the Drop Out Time parameter value, if nec-
essary.
Fader REC Accuracy: This parameter sets the accuracy of recording faders over time to
“Little,” “Some,” “More,” or “Most.” If you set the parameter to lower values, you will save
Automix memory space.
Insert Time Link: This parameter enables you to select the locate memory used for the
IN and OUT parameters in the Insert operation.