Yamaha WC42260 - Manual (Page 342)

342
Appendix B: Specifications
DM2000—Owner’s Manual
Input Channel CH1–96
Input patch —
Phase Normal/reverse
Gate-type 3
On/off
Key in: 12 ch Group (1–12, 13–24, 25–36, 37–48, 49–60, 61–72, 73–84,
85–96)/AUX1–12
Comp-type 4
On/off
Key in: self /Stereo Link
Pre EQ/pre fader/post fader
Attenuator –96.0 to +12.0 dB (0.1 dB step)
EQ
4-band PEQ 5
On/off
Delay 0–43400 samples
On/off —
Fader 100 mm motorized (INPUT/AUX1–12)
Aux send
On/off
AUX1–12; pre fader/post fader
Solo
On/off
Pre fader/after pan
Pan 127 positions (Left= 1–63, Center, Right= 1–63)
Surround pan 127 × 127 positions
LFE level – ∞, –96 dB to +10 dB (256 step)
Routing STEREO, BUS1–8, DIRECT OUT
Direct out Pre EQ/pre fader/post fader
Metering
Displayed on LCD
Peak hold on/off
TALKBACK
Level control Analog rotary potentiometer
AD converter 24-bit linear, 128-times oversampling
Talkback select Built-in microphone/AD IN 1–24
On/off —
Slate On/off
OSCILLATOR
Level 0 to –96 dB (1 dB step)
On/off —
Waveform Sine 100 Hz, sine 1 kHz, sine 10 kHz, pink noise, burst noise
Routing BUS1–8, AUX1–12, MATRIX 1L–4R, STEREO L, R
STEREO OUT DA converter 24-bit linear, 128-times oversampling
OMNI OUT 1–8
Output patch
SURROUND MONITOR, STEREO, BUS1–8, AUX1–12, MATRIX 1L–4R,
DIRECT OUT 1–96, INSERT OUT (CH1–96, BUS1–8, AUX1–12,
MATRIX 1L–4R, STEREO)
DA converter 24-bit linear, 128-times oversampling
CONTROL ROOM
MONITOR OUT (LARGE,
SMALL)
Monitor select
STEREO, 2TR IN DIGITAL 1, 2TR IN DIGITAL 2, 2TR IN DIGITAL 3, 2TR I N
ANALOG 1, 2TR IN ANALOG 2, ASSIGN 1, 2 (BUS 1–8/AUX 1–12/MATRIX
1–4)
Solo contrast –96 to 0 dB (1 dB step)
Mono On/off
Dimmer On/off
DA converter 24-bit linear, 128-times oversampling
Level control Analog rotary potentiometer
Phones level Analog rotary potentiometer
Small trim Analog rotary potentiometer
STUDIO MONITOR OUT
Monitor select CONTROL ROOM, STEREO, AUX 11, AUX 12
DA converter 24-bit linear, 128-times oversampling
Level control Analog rotary potentiometer
2TR OUT DIGITAL 1–3
Dither
On/off
Word length 16, 20, 24-bit
Output patch
STEREO, BUS1–8, AUX 1–12, MATRIX 1L–4R, DIRECT OUT 1–96, INSERT
OUT, CONTROL ROOM
SRC On/off (1:3 and 3:1 maximum input to output sample rate ratio)