Yamaha WC42260 - Manual (Page 38)

38
Chapter 2—Control Surface & Rear Panel
DM2000 Version 2—Owner’s Manual
D IN button
Pressing this button transmits a Locate command to the target machine (DAW, MMC or
P2) in order to locate the In point. Its indicator lights up momentarily when it’s pressed. See
“Using the Locator” on page 258 for more information.
E OUT button
Pressing this button transmits a Locate command to the target machine (DAW, MMC or
P2) in order to locate the Out point. Its indicator lights up momentarily when it’s pressed.
See “Using the Locator” on page 258 for more information.
F POST button
Pressing this button transmits a Locate command to the target machine (DAW, MMC or
P2) in order to locate the Post-Roll point. Its indicator lights up momentarily when it’s
pressed. The Post-Roll point is a predefined number of seconds after the specified Out
point. See “Using the Locator” on page 258 for more information.
G SET button
This button is used when specifying the eight Locate points, In point, Out point, and Return
to Zero point. Its indicator lights up while it’s pressed. See “Using the Locator” on page 258
for more information.
H MTR button
This button is used to select the MTR machine for Locator, Transport, Scrub, and Shuttle
control (MMC or P2). Its indicator lights up when MTR is selected (the [MASTER] button
indicator goes off). See “Using the Locator” on page 258 for more information.
I LOCATE MEMORY 1–8 buttons
Pressing these buttons transmits Locate commands to the target machine (DAW, MMC or
P2) in order to locate the Locate memory points. Their indicators light up momentarily
when they’re pressed. See “Using the Locator” on page 258 for more information.
J RETURN TO ZERO button
Pressing this button transmits a Locate command to the target machine (DAW, MMC or
P2) in order to locate the Return to Zero point. Its indicator lights up momentarily when
it’s pressed. See “Using the Locator” on page 258 for more information.
K END button
Pressing this button transmits a Locate command when using the DAW Remote Layer in
order to locate the end of the session. Its indicator lights up momentarily when it’s pressed.
See “About Remote Layers” on page 253 for more information.
L ONLINE button
This button is used to turn the Chase function on and off on the target machine (DAW,
MMC or P2). Its indicator lights up while the Chase function is on. See “Using the Locator”
on page 258 for more information.
M LOOP button
This button is used to turn on and off Loop Playback on the target machine (DAW, MMC
or P2). Its indicator lights up when Loop Playback is on. See “Using the Locator” on page
258 for more information.
N QUICK PUNCH button
This button is used to turn on and off the Quick Punch function on the target machine
(DAW, MMC or P2). Its indicator lights up when Quick Punch is on. See “Using the Loca-
tor” on page 258 for more information.
O ROLL BACK button
This button is used to roll back (i.e., rewind) the target machine (MMC or P2) from the cur-
rent position by a predefined amount. Its indicator lights up momentarily when it’s pressed.
See “Using the Locator” on page 258 for more information.