Yamaha WC42260 - Manual (Page 327)

Effects Parameters
327
DM2000—Owner’s Manual
OCTA REVERB
Eight input, eight output reverb.
AUTO PAN 5.1
Six input, six output autopanner for 5.1 surround. You can reset to the pan position specified by
the OFFSET parameter by pressing the RESET button.
CHORUS 5.1
Six input, six output chorus for 5.1 surround.
Parameter Range Description
REV TIME 0.3–99.0 s Reverb time
REV TYPE Hall, Room, Stage, Plate Reverb type
INI. DLY 0.0–100.0 ms Initial delay before reverb begins
HI. RATIO 0.1–1.0 High-frequency reverb time ratio
LO. RATIO 0.1–2.4 Low-frequency reverb time ratio
DIFF. 0–10 Reverb diffusion (left–right reverb spread)
DENSITY 0–100% Reverb density
E/R BAL. 0–100%
Balance of early reflections and reverb
(0% = all reverb, 100% = all early reflections)
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
Parameter Range Description
SOURCE
OFF, HOLD, INPUT1,
INPUT2, INPUT3,
INPUT4, INPUT5,
INPUT6, MIDI When set to OFF, the TRIGGER button is used to start autopan.
When set to HOLD, autopan runs continuously. When set to INPUT
1–6, the specified channel’s input signal triggers autopan. When set
to MIDI, a MIDI Note On message can be used to trigger autopan.
TRIG. LVL –60 to 0 dB
Input trigger level (i.e., the signal level required to trigger panning
when SOURCE set to INPUT)
TRG MASK 0–1000 ms
Trigger Mask specifies the time from when a trigger is received until
the next trigger will be accepted.
TIME 0.0 s–10.0 s The time after which autopan starts once it’s been triggered
SPEED 0.05 Hz–40.00 Hz Autopan speed
DIR. Turn L, Turn R Autopan direction
OFFSET –180 to +180 degrees Pan offset
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
Parameter Range Description
FREQ. 0.05–40.00 Hz Modulation speed
AM DEPTH 0–100% Amplitude modulation depth
PM DEPTH 0–100% Pitch modulation depth
MOD. DLY 0.0–400.0 ms Modulation delay time
WAVE Sine, Tri Modulation waveform
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
SYNC OFF/ON Tempo parameter sync on/off
NOTE 1
1.
Used in conjunction with TEMPO to determine FREQ.