Yamaha WC42260 - Manual (Page 78)

78
Chapter 6—Input & Output Patching
DM2000 Version 2—Owner’s Manual
Patching Input Channel Insert Ins
AD Inputs, Slot Inputs, internal effects processor outputs, Digital or Analog 2TR Inputs can
be patched to the Input Channel Insert Ins.
The Input Channel Insert In Patch parameters for the 96 Input Channels are divided
between two pages. The Input Channel 1–48 Insert In Patch page is shown below. The lay-
out of the other page is the same. When Vertical Input Channel pairing mode is selected,
patch parameters for vertical partners are displayed, for example, CH1, CH25, CH2, CH26,
and so on.
In addition to using the cursor buttons, Patch parameters can also be selected by using the
[SEL] buttons.
Patching Effects Inputs and Outputs
Aux Sends, internal effects processor outputs (OUT1 and OUT2 only), or Output Channel
Insert Outs can be patched to the internal effects processor inputs.
Input Channels, or Insert Ins can be patched to the internal effects processor outputs. Inter-
nal effects processor inputs can be also patched to the internal effects processor outputs
(OUT1 and OUT2 only).
The internal effects processor Input Patch parameters are divided between two pages: One
for Effects Processors #1 and #2, and one for Effects Processors 3–8. The effects type for each
Effects Processor is displayed in the boxes.
FOLLOW SURROUND: When surround effects are recalled to Effects processor 1 or 2,
this button sorts the effect inputs and outputs displayed in the list in the order specified on
the Surround Bus Setup page (see page 99). If the recalled surround effects are compatible
with 5.1 Channel systems, the surround bus setting for 5.1 surround mode will be used.
: Press this button repeatedly until an Effect Edit (1–8) page for the effects processor you
wish to edit appears.