Yamaha WC42260 - Manual (Page 147)

Group Master for the Output Channel Faders
147
DM2000 Version 2—Owner’s Manual
2 Press the LAYER [MASTER] button.
3 Use the Up/Down cursor buttons to select Fader groups Q–T.
The selected group is highlighted by a flashing cursor box.
4 Use the [SEL] buttons to add and remove Output Channel faders to and from
the selected group.
When an Output Channel is added to a group, its [SEL] button indicator lights up.
ENABLE: These buttons are used to enable and disable the groups.
OUTPUT FADER MASTER: When this check box is not checked, the Output Channel
fader positions determine the fader levels in the Output Channel Fader groups. When this
check box is checked, you can set the master level for the corresponding Output Channel
Fader group in the Master column. The resultant Output Channel level equals the corre-
sponding Output Channel fader level plus the Group master level. See “Group Master for
the Output Channel Faders” on page 147 for more information.
When the Output Fader Master check box is not checked, operating the channel faders will
affect the Output Channel levels in the corresponding Fader group. Pressing and holding
down the [SEL] button while operating the fader of an Output Channel will temporarily
cancel the corresponding Fader group, which is convenient if you want to adjust the relative
balance between channels.
Fader groups are active only in Fader mode. See “Selecting Fader Modes” on page 60 for
more information.
Group Master for the Output Channel Faders
The DM2000 also features a Fader Group Master function that enables you to control the
level of all channels using the Group Master level while maintaining the balance between
the channels, much like a VCA Group on an analog mixing console. While this function is
enabled, channel fader operation will not affect the channel levels of the corresponding
Fader group.
1 Follow Steps 1–4 as described in the “Grouping Output Channel Faders” sec-
tion on the previous page, select the Output Fader Master check box, then
press the [ENTER] button to check or uncheck the Output Fader Master check
box.
2 When the Output Fader Master check box is checked, you can set the channel
levels of the Fader groups in the Master column.
When the Master column is selected, repeatedly pressing the [ENTER] button turns the
Output Fader Group on and off.