Yamaha WC42260 - Manual (Page 164)

164
Chapter 13—Monitoring & Talkback
DM2000 Version 2—Owner’s Manual
The Slate function distributes the Talkback mic signal to all Bus Outs, Matrix Sends, and the
Stereo Out.
The [SLATE] button has two modes of operation: If it’s pressed once (i.e.,
for less than 300 ms), the Slate function is turned on and remains on when
the button is released. This is Latched mode. If it’s pressed and held for
longer, the Slate function is turned on, but turns off when the button is
released. This is Unlatched mode. The [SLATE] button indicator flashes
while the Slate function is active.
Talkback Setup
1 Use the MONITOR [DISPLAY] button to locate the Talkback Setup page.
2 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
OUTPUT ASSIGN: These buttons are used to assign the Talkback mic signal to Slot and
Omni Outputs.
STUDIO MONITOR: This allows you to select the Talkback mic signal as the Studio
Monitor source.
TALKBACK DIMMER LEVEL: When the Talkback function is active, this determines the
amount of attenuation applied to sound sources assigned to the Studio Monitors and
selected for Talkback.
USE AD IN x AS TALKBACK: This allows you to select an AD Input as the Talkback sig-
nal source. Use the check box to turn this option on and off, and use the number parameter
to specify the number of the AD Input. The signal from the specified AD Input is mixed
with the Talkback mic signal. Turn down the TALKBACK LEVEL if you do not want to use
the Talkback mic.
NEVER LATCH TALKBACK: This options allows you to disable Talkback latching.
SLATE