ZyXEL Communications 2864 User Manual
Page 165
15–11
+FNS="
string
"
Non-standard byte string parameter.
"string": string of hexadecimally coded octets.
+FPI="
string
"
Local fax station ID string, for polling Rx.
+FPP=n
Packet protocol control parameter:
n=0
Disables the DCE-DTE packet protocol.
n=1
Enables the DCE-DTE packet protocol. All multi-
character messages from the DCE are sent to the
DTE using a simple packet protocol data link.
+FPR=n
Serial port rate control parameter:
n=0
Automatic DTE rate detection by the DCE.
n>0
Serial rate is fixed at the value multiplied by
2400bps. For example, when n=8, the DTE
rate is equal to 19200bps (8x2400).
+FPS=n
Page transfer status: refer to the +FPTS Class 2
command on page 15-6 for parameter
descriptions.
+FRQ=pgl, cbl
Receiving quality thresholds parameters:
pgl=
0-64
(HEX
value)
Specifies the percentage of good lines (e.g. with
negotiated number of pixels) required for a page
considered acceptable. The percentage of good
lines would be computed by the equation:
100 x (
lc: total line count as reported in the +FPS:
response.
bl: bad line count as reported in the +FPS:
response.
If the resulting value is less than the value in
cbl=
0-FF
(HEX
value)
Specifies the maximum tolerable number of
consecutive bad lines. If this value is exceeded
for a given page, the DCE shall consider the
page unacceptable.
+FRY=n
0-255
ECM retry value: n=0-255, units of 4 retries.
+FSP=n
Enable polling command:
n=0
Disables polling.
n=1
Enables polling.