ZyXEL Communications 2864 - Manual (Page 164)

15–10
+FIS=vr,br,wd,ln,
df,ec,bf,st Current session parameter: refer to the +FDCC
Class 2 command on page 15-4 for parameter
settings.
+FKS Session termination command.
+FLI="
string
" Local ID string parameter.
+FLO=n Flow control options:
n=0 No flow control.
n=1 Sets XON/XOFF software flow control.
n=2 Sets CTS/RTS hardware flow control.
+FLP=n Document for polling command:
n=0 The DTE has no document for polling.
n=1 Indicates that a document is available for polling.
+FMI? Requests DCE manufacturer identification.
+FMM? Requests DCE model identification.
+FMR? Requests DCE revision identification.
+FMS=n Minimum phase C speed parameter: refer to
the +FMINSP Class 2 command on page 15-6
for parameter settings.
+FNR=rpr, tpr,
idr, nsr Negotiation message reporting control parame-
ters:
rpr=0 Receiver parameters are not reported. +FIS:
and +FTC: response reports are suppressed.
rpr=1 Receiver parameters are reported. +FIS: and
+FTC: response reports are generated.
tpr=0 Transmitter Parameters are not reported. +FCS:
response reports are suppressed. (+FCS
parameter is still loaded)
tpr=1 Transmitter Parameters are reported. +FCS:
response reports are generated.
idr=0 ID Strings are not reported. +FTI: +FCI: and
+FPI: response reports are suppressed.
idr=1 ID Strings are reported. +FNF:, +FNS: and
+FNC: response reports are generated.
nsr=0 Non-standard frames are not reported. +FTI:
+FCI: and +FPI: response reports are sup-
pressed.
nsr=1 Non-standard frames are reported. +FTI:, +FCI:
and +FPI: response reports are generated.